TDA4VM: MCU2_1 compilation error

Cherry Zhou

Part Number: TDA4VM

Hi team,

Use make -j2 can_boot_app_mcu_rtos HLOSBOOT=linux BOOTMODE=mmcsd BOARD=j721e_evm SOC=j721e BUILDFILE=release CORE=mcu2_1 BUILD_OS_TYPE=freertos to compile and fails, as shown in the following figure:

Thanks.

Best Regards,

Cherry

over 3 years ago

0 Parth Nagpal over 3 years ago

TI__Mastermind 42135 points

Hi Cherry,

Can you please mention the SDK release that you are using?

Regards,
Parth

0 Cherry Zhou over 3 years ago in reply to Parth Nagpal

TI__Mastermind 22235 points

Hello Parth,

Thanks for your support.

Parth Nagpal said:
Can you please mention the SDK release that you are using?

It's 0806.

Thanks and regards,

Cherry

0 Cherry Zhou over 3 years ago in reply to Cherry Zhou

TI__Mastermind 22235 points

Hi,

May I know is there any updates?

Best,

Cherry

0 Tarun Mukesh Puvvada over 3 years ago in reply to Cherry Zhou

TI__Guru 59756 points

Hello,

Sorry for the delay. I am looking into this and will reply as early as possible.

Thanks

Tarun Mukesh

0 Tarun Mukesh Puvvada over 3 years ago in reply to Tarun Mukesh Puvvada

TI__Guru 59756 points

Hello,

https://software-dl.ti.com/jacinto7/esd/processor-sdk-rtos-jacinto7/latest/exports/docs/mcusw/mcal_drv/docs/drv_docs/demo_boot_app_mcu_rtos_top.html

In the above link you can find

The application performs the following actions:

MCAL Can driver is hosted on MCU1_0
Transmit a 64 byte CAN message, or, alternatively, run CAN profiling
Boot the main domain cores with a sample application image
Optionally, boots a HLOS (Linux, QNX) on the main domain MPU1_0

This demo application is tested only on MCU1_0 but not on MCU2_1.

Regards

Tarun Mukesh.

Processors

Processors forum

TDA4VM: MCU2_1 compilation error