Ethernet configuration for TM320C6748 DSP

Giuseppe Aliperti

Other Parts Discussed in Thread: OMAP-L138

Hi, I'm Giuseppe!

I'm working on a TI DSP and I'm searching a guide or informations to install and configure the ethernet port on my TM320C6748 DSP.

I also need to know the fundamental steps for this procedure. Could anyone help me?

Thanks!!!

over 14 years ago

0 Muhammad Haque over 14 years ago

TI__Intellectual 1000 points

Hi,

If you are using BIOS, the NDK (links below) may be a better option to try or use as a reference:

http://processors.wiki.ti.com/index.php/GSG_C6748:_Installing_the_SDK_Software
http://software-dl.ti.com/dsps/dsps_public_sw/sdo_sb/targetcontent/omap_l138/1_00/latest/index_FDS.html

If you are not using BIOS then you can use the Logic PD BSL(look for OMAP-L138 experimental board) test for EMAC as a reference? That test is only intended to check for board functionality -- it is not a driver. You may have to register with LogidPD to access the BSL.

http://www.logicpd.com/products/development-kits/zoom-omap-l138-experimenter-kit

Regards,

Muhammad

Processors

Processors forum

Ethernet configuration for TM320C6748 DSP