SK-AM62A-LP: SK-AM62A-LP (HS-FS) Not able to boot

Biswa bhusan Maharana

Part Number: SK-AM62A-LP

I am facing some challenge to boot SK-AM62A-LP EVM. As per quick start guide i have downloaded images and as per guide i have flashed on SD card and i have set boot switch for SD card SW 3.7 ON, SW 3.6 OFF, SW3.5 OFF, SW 3.4 OFF rest of all default mode.

over 2 years ago

0 Jianzhong Xu over 2 years ago

TI__Guru 62600 points

Hello Biswa,

Your boot switch setting doesn't sound correct. It should be set as shown in the picture below:

Were you looking at this quick start guide?

Regards,

Jianzhong

0 Biswa bhusan Maharana over 2 years ago in reply to Jianzhong Xu

Prodigy 90 points

Hello Jianzhong Xu,

already I have followed quick start guide as you mentation, but it doesn't work.

0 Jianzhong Xu over 2 years ago in reply to Biswa bhusan Maharana

TI__Guru 62600 points

Do you know if your board is a GP or HS-FS device? Which SDK version are you using?

In addition, would you mind taking a picture of your board and sharing it here?

Thanks,

Jianzhong

0 Biswa bhusan Maharana over 2 years ago in reply to Jianzhong Xu

Prodigy 90 points

According to the name of the system-on-a-chip (SoC), it's supposed to be a GP (General Purpose) device. However, when I decoded some hexadecimal values received from the UART (Universal Asynchronous Receiver-Transmitter), it indicated that it's actually recognized as an HS-FS (High-Speed Full-Speed) device. I also followed the quick start guide for the GP device, but unfortunately, it didn't successfully boot up.