• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 98 subscribers
  • Views 147 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

SK-AM62: E2E old thread reopen

veerapandiyan v
Intellectual 870 points
Part Number: SK-AM62

Hi everyone,

 I have used SK-AM62  E3 REVISION sitara board. I am rising some doubts but not clear doubts not reply  your ti guys please support below three threads

1.Bluetooth:

        1.I have enable UART1 and UART2 in ccs software but bluetooth is not enable using bluez function.
        2.I am editing dts file also it's not working bluetooth using bluez function.
3.How to load bare-metal code in hypervisor i referred am62x document but not work adding bare-metal code. I asking TI e2e forum  link: https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1281692/sk-am62-how-to-load-baremetal-code-in-hypervisor/4860953?tisearch=e2e-sitesearch&keymatch=%2520user%253A545048#4860953
Thanks Regards,
Veerapandiyan V.
  • 0
    TI__Guru 69657 points

    Hi Veerapandiyan,

    unfortunately at the moment there is no bandwidth to further support the threads you pointed to beyond the initial guidance that was given there so I'll close this one here as it essentially is a duplicate thread. If you absolutely cannot proceed here any further please raise/escalate this with your local TI representative.

    Regards, Andreas