Connect to EVM-L138 with errors using xds100v2?

jian gong

Other Parts Discussed in Thread: OMAP-L138

Hi ,everyone!

I'm using EVM-L138, I setted the S7 on the baseboard to boot from EMU. I also setted the target conifguration file as follow:

On connectting to my EVM-L138,it always encounters with the following error.

what's the address 0x01C11138?

Thanks a lot.

Best Regards!

jiangong

0 Kiung Chung Wong over 14 years ago

Expert 2110 points

you might want to check Memory Map in SPRS586B.

I think this is one of the registers for PLL Controller 0 (0x01c1 1000 - 0x01c1 1fff)).

rgds,

kc Wong

0 dabuan over 14 years ago

I've run into the same error using the GEL file provided with the OMAP-L138 LogicPD board.

It's been a while, so I don't remember the exact details, but I worked around it it by removing the call in the GEL file that made this call.

Processors forum