Decode and Display

bharatgohil

Intellectual 475 points

Hi,

We developing NVR(Network Video Recoder) using DVR RDK.

I have modified Decode and display demo for ip camera and works fine.(Decode 16 H264 stream and display).

Now, I want enable QT graphic. Can tell me procedure for same?

Regards,

Bharat Gohil

over 13 years ago

0 Arun Menon over 13 years ago

TI__Expert 6505 points

Hi Bharat,

If you are using DVR RDK, we have a DVR RDK GUI demo too with it. This GUI demo uses QT graghics and integrates the progressive DVR demo(you can change the demo if tyou wish but our GUI is made for 16ch progressive demo) with it. Please refer to dvrapp folder in DVR RDK for further details.

Regards,

Arun

0 bharatgohil over 13 years ago in reply to Arun Menon

Intellectual 475 points

Hi,

I check gui demo from udworks.

dvr application is tietly coupled with Video capture part but no more use video capture part

My question is simple ,i want to access /dev/fb0 then what is procedure to enable it.

Simply i want run gui application say analog clock.(Dont want capture ,encode ,decode and etc)

Regards,

Bharat Gohil

0 zhang yan over 13 years ago in reply to bharatgohil

Prodigy 160 points

hi,

The capture_encode demo works well. but I want to use dm8168 for dvr (multi-pipes D1), In ezsdk5.02 , the omx component can't support D1 capture? How can i make it ture?

How can i get the "DVR RDK" and the "DVR RDK GUI demo"?

best regards

zhang yan

0 bharatgohil over 13 years ago in reply to zhang yan

Intellectual 475 points

Hi,

We got DVR RDK from ti.

You have to buy DVR RDK for GUI from UDWORKS.

If you have RDK then i can guide you.

Regards,

Bharat Gohil

0 miaoyun huang over 12 years ago

Prodigy 50 points

hi can you tell me the modified method, I used openrtsp to recieve rtsp stream to a file and use the vdec_vdis demo to display ,but not realtime enought .

help ~~send me your works fine codes to my email ok?415678659@qq.com

Processors

Processors forum

Decode and Display