A problem about how to use the hyper terminal

liang

Hi everyone,

Recently I am testing the Flash booting. Refered to the readme.txt provided by MCSDK, I cann't observe the output. Can anyone which haved succeed doing the FLash booting tell me the detail step to use the Hyper Termianl. Thank you.

Best Regards

over 13 years ago

0 Chad Courtney over 13 years ago

TI__Mastermind 30825 points

What device are you using?

0 liang over 13 years ago in reply to Chad Courtney

Intellectual 290 points

EVM6678

0 Asmit Patel over 13 years ago in reply to liang

Prodigy 120 points

Hi Liang,

On windows Hyper Terminal is available at start->Accessories->Communication->Hyper Terminal.

Click on that and select a COM port number whatever available on your computer.

Then set values as below:

1) Baud Rate - 115200

2) Data Bits - 8

3) Parity - None

4) Stop Bits - 1

5) Flow Control - None.

Power on the Hardware and check output on Hyper Terminal.

Thanks

Asmit

Processors

Processors forum

A problem about how to use the hyper terminal