Processors

Processors forum

State TI Thinks Resolved
+1 person also asked this people also asked this
Locked Locked
Replies 7 replies
Answers 1 answer
Subscribers 100 subscribers
Views 950 views
Users 0 members are here

Support feedback

Options

Options

Related

[FAQ] SK-AM62A-LP: Is USB OTG possible without PD controller?

Sathiya Narayanan

Intellectual 840 points

Part Number: SK-AM62A-LP
Other Parts Discussed in Thread: AM62P, SK-AM62P-LP, PROCESSOR-SDK-AM62A

Tool/software:

Hi,

For my application, I don't need PD controller for power negotiation. But in SK-AM62A-LP design, PD controller is also used for role detection. Is there any way to avoid PD and directly implement role detection on AM62A processor? or with small circuitory?

over 1 year ago

0 Kallikuppa Sreenivasa over 1 year ago

TI__Guru**** 233255 points

Hello Sathiya Narayanan

Thank you for the query.

AM62P support dual role using any of the SOC IOs.

Regards,

Sreenivasa

0 Sathiya Narayanan over 1 year ago in reply to Kallikuppa Sreenivasa

Intellectual 840 points

Hello Kallikuppa Sreenivasa,

I have checked SK-AM62P-LP's schematic and Linux device tree. It is handled same to that of SK-AM62A-LP.

My question is that,
If I remove PD controller, USB role detection is possible with any other mechanism?

0 Kallikuppa Sreenivasa over 1 year ago in reply to Sathiya Narayanan

TI__Guru**** 233255 points

Hello Sathiya Narayanan

You can use any of the IO to implement the dual role.

Regards,

Sreenivasa

0 Sathiya Narayanan over 1 year ago in reply to Kallikuppa Sreenivasa

Intellectual 840 points

Hello Kallikuppa Sreenivasa,

I also needed help from SDK side. Is there any example linux device tree implementing this?

0 Kallikuppa Sreenivasa over 1 year ago in reply to Sathiya Narayanan

TI__Guru**** 233255 points

Hello Sathiya Narayanan

Thank you.

Please share the development environment you are using.

I can reassign to the expert.

Regards,

Sreenivasa

0 Sathiya Narayanan over 1 year ago in reply to Kallikuppa Sreenivasa

Intellectual 840 points

Hi Kallikuppa Sreenivasa

I am using Processor-sdk-am62a (yocto).

SDK Version: 9.1+

0 Bin Liu over 1 year ago in reply to Sathiya Narayanan

TI__Guru**** 181776 points

Hi Sathiya,

You need to route

- both CC pins from the type-C connector to a single GPIO pin of AM62Ax;

- both VBUS pins from the type-C connector to the VBUS output of the VBUS power switch;

- the DP/DM pins on both sides of the type-C connector to the DP/DM pins of AM62Ax.

For kernel devicetree configuration, please refer to the usb0 node in the Critical Link devkit board DTS linked below.

https://support.criticallink.com/gitweb/?p=linux-ti.git;a=blob;f=arch/arm64/boot/dts/ti/k3-am62a7-mitysom-devkit.dts;h=e1ab3fe0db81e0e594175de0d3f5d405f2026f75;hb=refs/heads/mitysom-linux-6.6.y#l707