TDA4VM: How do I know csi_rx received image data

CHENG NUO

Prodigy 110 points

Part Number: TDA4VM
Other Parts Discussed in Thread: AM62P

Tool/software:

Hi experts,

Is there a register like the one below on the TDA4 platform that can determine whether to receive high speed clock?

Or is there a relevant register that determines that csi_rx received the image data?

6 months ago

0 Brijesh Jadav 6 months ago

TI__Guru**** 479805 points

Hi,

Sorry, did not get your question, this register is for receiver side, isn't it? CSITX outputs high speed clock, so it does not detect the high speed clock..

Regards,

Brijesh

0 CHENG NUO 6 months ago in reply to Brijesh Jadav

Prodigy 110 points

Hi Brijesh,

I asked about the csi_rx module, not the csi_tx module.

The registers in my diagram above are for the AM62P platform. I would like to ask if the TDA4 platform has similar registers.

0 Brijesh Jadav 6 months ago in reply to CHENG NUO

TI__Guru**** 479805 points

Hi Cheng,

If it is available AM62P, it should be available even on TDA4 platform, so can you please search for this register in the TRM?

Regards,

Brijesh

0 CHENG NUO 6 months ago in reply to Brijesh Jadav

Prodigy 110 points

Hi Brijesh，

I didn't find the relevant register in the TDA4 TRM documentation, so I made this post asking for your help.

Could you please help to find the relevant register?

+1 Brijesh Jadav 6 months ago in reply to CHENG NUO

TI__Guru**** 479805 points

Hi Cheng,

This register is available as shown below. You could find it in TRM.

Regards,

Brijesh

Processors

Processors forum

TDA4VM: How do I know csi_rx received image data