Tool/software:
Hi Expert,
As shown in the figure below, yellow is SPI CS, pink is SPI CLK, and blue is Data
Is it possible to make CS appear at the width of data and CLK? In other words, the part with red box in the figure below is redundant. How to adjust it here?
Thanks
Daniel
To add on top of this, on the TI EVM I have done some measurement for the time taken for the red boxes highlighted by the customer.
After the transaction the extra time for the chip select to go up is: 6.8 microsecond
Before the transaction, when the chip select goes down the first clock and the data comes after 1.39 microseconds.
This is just FYI.
Regards,
Vaibhav
