I'm having difficulty running the VC3 demo with SDK 5.03.00.09 (see output below). I added a little debug and the call to RcmClient_exec() in OmxRpc_rcmExec() in OmxRpcStubCommon.c does not return. This happens during the tunnel setup of the VFPCDE to VENC connection.
Any thoughts on whats wrong here?
root@dm816x-evm:~# /etc/init.d/matrix-gui-e stop
Stopping Matrix GUI application.
root@dm816x-evm:~# cd dm816x-evm/usr/share/ti/ti-omx
root@dm816x-evm:~/dm816x-evm/usr/share/ti/ti-omx# ./vc3_a8host_debug.xv5T 127.0.
0.1 10000 60
SDK - VC Demo
=============
Bitrate: 10000 kbps, framerate 60 fps
UIAClient is ready to send a UIA configuration command
UIAClient received UIA_CONFIGURE_ACK
UIAClient is done sending requests
UIAClient is ready to send a UIA configuration command
UIAClient received UIA_CONFIGURE_ACK
UIAClient is done sending requests
Entering : OMX_HDVPSS_MicroChain_Test
In Codec_SetBitRate: Bit rate is 10000000
In Codec_SetFrameRate: Frame rate is 60
VFCC:0
VFDC:0
VFDC:0
VFPC_DEI:0
VENC_0 Port 0 Disabled
VFPC_VENC_H264:0
VENC_0 Port 1 Disabled
VDEC_0 Port 0 Disabled
VDEC_0 Port 1 Disabled
VFPC_VDEC_H264:0
VFCC Port 0 Enabled
VFPCDEI_1 Port 0 Enabled
VFPCDEI_1 Port 16 Enabled
VFDC_0 Port 1 Enabled