AM62P-Q1: how many external crystal needed?

liujian zhang

Part Number: AM62P-Q1

Tool/software:

Hello,

as below show, does low frequency oscillators(32.768KHz) must be have ? and what's means "clock to Timers" , if we have PWM output in our real application, does this mean this 32.768KHz oscillator needed?

thanks!

7 months ago

0 Stanislav Stilyanov 7 months ago

TI__Mastermind 23620 points

Hi liujian zhan,

Speaking about Timers, there a good variety of functional clocks to select from:

Also, the 32.768k oscillator can be replaced with 32k clock divided from HFOSC clock or 32k RC clock:

Additionally, the 32.768k oscillator is used for the RTC module especially in during low-power modes.

You can skip the 32,768k crystal if the RTC is not required.

Regards,

Stan

0 Kallikuppa Sreenivasa 7 months ago in reply to Stanislav Stilyanov

TI__Guru**** 211060 points

Hi liujian zhan,

WKUP_LFOSC0 has limited use case.

We are recommending customers to provide provision to pulldown the Xi input when not used.

Refer below FAQ. We have schematics embedded with design notes that can be referenced during custom board design.

https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1340906/faq-am62p-am62p-q1---custom-board-hardware-design---design-and-review-notes-for-reuse-of-sk-am62p-lp-schematics

Regards,

Sreenivasa

Processors

Processors forum

AM62P-Q1: how many external crystal needed?