LFTB test for SATA

leon huang

Prodigy 10 points

hi,

I am using the LFTB tool to test the SATA performance, but there's a problem I encouter, that is :

when I test the SATA performance, I can't get any result nor log such:

EVM: 8168 Netra DVRRD Rev0.3A

could somebody know what happens? Should I make some special settings?

over 13 years ago

0 Deepti Vaidya over 13 years ago

TI__Prodigy 120 points

Hi Leon,

You can use LTP-DDT to get SATA performance. LTP-DDT is derived from LFTB and the same test is available on LTP-DDT.
You can get LTP-DDT from arago:
http://arago-project.org/git/projects/?p=test-automation/ltp-ddt.git;a=summary

You will need to compile it for Netra, the steps are mentioned in README-DDT.
You need to use the platform name am389x-evm.

You need to use the following command on target
./runltp -P am389x-evm -f ddt/sata_perf_vfat -s "SATA_L_PERF_VFAT_0001
This will give you the performance nos. for vfat. You can check the log for PERF_DATA.

Hope this helps.

Regards,
Deepti

Processors

Processors forum

LFTB test for SATA