AM62A7-Q1: New SDK 11.02 is not working on EVM after yocto build

Hi Satyajeet,
You have mentioned in the title that you have done Yocto build. Can you please try flashing https://dr-download.ti.com/software-development/software-development-kit-sdk/MD-D37Ls3JjkT/11.01.07.05/tisdk-edgeai-image-am62a-evm-11.01.07.05.rootfs.wic.xz directly and then trying. This help remove any Yocto variabilities.

Hi Divyansh,

As you suggested i have build the SDK 11.02 in audio thread, but your shared link is for 11.01.

Is there any difference between them?

Regards,

Satyajeet

Hello,
Thank you for your query. The concerned expert is Out of Office due to **TI India** Holiday.
Please expect a delay in response. We appreciate your patience and understanding.

Best regards,
TI E2E Support Team
---
*This is an automated notification.*

Hello,

Satyajeet Singh said:

As you suggested i have build the SDK 11.02 in audio thread, but your shared link is for 11.01.

The 11.02 is not yet officially released

www.ti.com/.../PROCESSOR-SDK-LINUX-AM62A

Hi 

I have build 11.02 as suggested in my audio thread 

AM62A3-Q1: Platform sound: deferred probe pending on AM62A3 custom board - Audio forum - Audio - TI E2E support forums.

I have downloaded the 11.01 wic image your provided link.

But this image is also not working.

I have tried in two different SD card with bmap tool and balenaEtcher tool.

Regards,

Satyajeet

Hello,

Satyajeet Singh said:

I have tried in two different SD card with bmap tool and balenaEtcher tool.

Are these from different brands?

Not sure what is causing the issue, but you may do the changes discussed in the following thread which initializes the SD card in lower speed mode and so should boot successfully.

e2e.ti.com/.../sk-am62p-lp-how-to-set-sd-card-to-3-3v-only-low-speed