UART2 in CIR mode for TI 8148

REHAN KHAN

Hi,

I want to use UART2 in CIR mode for TI 8148. what are the register settings i need to do for interrupt based receiver. Please reply

Regards,

Rehan Khan

over 13 years ago

0 K Md Feroz Irfan over 13 years ago

TI__Expert 7225 points

Hi Mr. Rehan,

Firs thing: Could you check the pin mux conflicts if any?

Which is the PSP version you are using? Please check the UART driver code if it supports CIR.

http://processors.wiki.ti.com/index.php/DM814x_AM387x_PSP_User_Guide

Hi TI Team,

Can you please advise?

Best Regards

Feroz

0 REHAN KHAN over 13 years ago in reply to K Md Feroz Irfan

Prodigy 100 points

Hi,

Actually I did error while writing this post. I am using UART1 RXD as CIR input not UART2. I will repost this query on related forum with my configuration.

Regards,

Rehan Khan

0 Nageswari Srinivasan over 13 years ago in reply to REHAN KHAN

TI__Expert 5660 points

Hi,

We do not support CIR mode in UART1 yet and will be available as part of 2Q PSP release.

Regards,

nageswari

0 REHAN KHAN over 13 years ago in reply to Nageswari Srinivasan

Prodigy 100 points

is there any other UART port supports CIR mode?

Processors

Processors forum

UART2 in CIR mode for TI 8148