flashing withour CCS ?

ranchu

Guru 20755 points

Hello,

I would like to have the ability to flash dm8168 without CCS. Is it possible ?

Regards,

Ran

over 13 years ago

0 Anil over 13 years ago

TI__Expert 6655 points

Hi Ran

Go through these link

http://processors.wiki.ti.com/index.php/TI81XX_PSP_U-Boot#Flashing_U-Boot_without_CCS

Regards

AnilKumar

Please mark this Forum post as answered via the Verify Answer button below if it helps answer your question. Thanks!

0 ranchu over 13 years ago in reply to Anil

Guru 20755 points

Hi Anil,

Thanks for the post. It means that if we want this feature(flashing without CCS) in the final board, we need to have the ability to change the boot register in hardware (with switch for example as done in the EVM). without that, the CCS must be used for flashing, am I right ?

Ran

0 Anil over 13 years ago in reply to ranchu

TI__Expert 6655 points

Hi Ran,

Yes, switch is required (with out this switch how can we change the boot modes?) otherwise CCS is the only option we have

Regards

AnilKumar

Please mark this Forum post as answered via the Verify Answer button below if it helps answer your question. Thanks!

0 ranchu over 13 years ago in reply to Anil

Guru 20755 points

Hi Anil,

Thanks for the answer. I see that there is also a CCS free version in TI web page. What is the diffrenece between the free version and the other versions ? (What is the Limit on the free limited version). I ask the question because I want to use CCS just for flashing purpose.

Thank You,

Ran

0 Anil over 13 years ago in reply to ranchu

TI__Expert 6655 points

Hi Ran,

Better open a new thread for this question in CCS forum

http://e2e.ti.com/support/development_tools/code_composer_studio/f/81.aspx

Regards

AnilKumar

Please mark this Forum post as answered via the Verify Answer button below if it helps answer your question. Thanks!

Processors

Processors forum

flashing withour CCS ?