Kitl over EMAC BeagleBone

Raj Kumar

Hi,

Please help me in getting the Kitl working over ethernet on BeagleBone with Adeneo BSP (version 2_30) ? Its even better if someone has RNDIS/USBserial support for debugging.

I see the problem with EMAC driver, it is not able to send any packet out.

Thanks,

Raj

over 13 years ago

0 Raj Kumar over 13 years ago

Prodigy 80 points

Hi ,

If this is not the right forum for the above query please let me know where to get the support from ?

Regards,

Raj

0 Adeneo Embedded support team over 13 years ago in reply to Raj Kumar

Mastermind 9310 points

Hi Raj

This is a problem related with the BeagleBone board Rev. A4. If this is the version that you have, what you can do is to remove the following resistor in your BB board: R219. After removing that resistor, your ethernet connection will start sending packets.

Processors

Processors forum

Kitl over EMAC BeagleBone