CCS Settings custom debugger

Raghu Kumar

Other Parts Discussed in Thread: TMS320C5515

We are FT2232HL chipset for debugger,and the processor is TMS320C5515 in our custom board. After installing drivers for this chipset, do we need any settings to be done in CCS to configure the debugger? Could you please let us know the procedure to make use of debugger in custom board.

over 13 years ago

0 Mark M over 13 years ago

TI__Mastermind 30120 points

Hi Raghu,

Here are the steps... http://processors.wiki.ti.com/index.php/XDS100#How_to_make_an_XDS100_.2F_How_to_build_an_XDS100_hardware_emulator

Rough summary...

1. Program FTDI EEPROM

FTDI chip reads configuration from connected EEPROM device. FTDI provides a programmer for the EEPROM:

http://www.ftdichip.com/Support/Utilities.htm#FT_Prog

You can either use the FT_Prog to read and copy the template from an existing eZdsp (recommended) or refer to the XDS100 wiki:

http://processors.wiki.ti.com/index.php/XDS100#Q:_What_should_the_USB_device.27s_UID_.28VID.2FPID.29_be.3F

2. Install CCS to install the XDS100 drivers. If already installed, then confirm that XDS100 Channel A and Channel B appear in Device Manager. See http://processors.wiki.ti.com/index.php/XDS100#Troubleshooting

3. Create target configuration in CCS and connect to the target...

Hope this helps,
Mark

Processors

Processors forum

CCS Settings custom debugger