Hi everyone,
gd noon!!!!
I'm getting the following error message while inserting micro SD card(transcend 1GB)
mmc0: host does not support reading read-only switch. assuming write-enable.
mmc0: new high speed SD card at address 0002
mmcblk0: mmc0:0002 00000 971 MiB
mmcblk0: p1 p2
and getting the following error while removing SD card from kit.
mmc0: card 0002 removed
mmcblk0: error -110 sending status comand
mmcblk0: error -110 sending read/write command, response 0x0, card status 0x900
mmcblk0: error -110 requesting status
end_request: I/O error, dev mmcblk0, sector 2
Buffer I/O error on device mmcblk0p1, logical block 1
lost page write due to I/O error on mmcblk0p1
mmcblk0: error -110 sending status comand
mmcblk0: error -110 sending read/write command, response 0x0, card status 0x900
mmcblk0: error -110 requesting status
end_request: I/O error, dev mmcblk0, sector 2
Buffer I/O error on device mmcblk0p1, logical block 1
lost page write due to I/O error on mmcblk0p1
FAT: bread failed in fat_clusters_flush
please do the needful help!!!!!!!
--Titus.
