Cannot Debug

Michelle Lopez

Hello,

I am using CCS v5 and sys/bios 6.33.05.46. Am using logic pd's evmomapl138 and spectrum digital xds560v2.

I am trying to run some of the generic examples. I am able to build it but when I go to the debug mode I cannot step through or run the example. Anyone has any input about this?

Thanks,

Michelle

over 13 years ago

0 Steven Connell over 13 years ago

TI__Mastermind 45025 points

Hi Michelle,

Can you check your project settings to ensure that it is being built for debug mode? In summary, you'll want to throw the -g flag for debug, set optimization to level 0, and set the RTSC configuration build to be debug.

Please see the screen shots for how to do this.

Steve

0 Michelle Lopez over 13 years ago in reply to Steven Connell

Intellectual 650 points

No, that's not it ( I had it configured as you suggested the only thing I had to change was the optimization level to 0 since it was in disable). Still having the same issues.

0 Steven Connell over 13 years ago in reply to Michelle Lopez

TI__Mastermind 45025 points

What code are you trying to step through? Is it your application code? Or BIOS kernel code?

Can you try this setting in your configuration file? This will build the BIOS libraries in debug mode for your application.

Steve

0 Michelle Lopez over 13 years ago in reply to Steven Connell

Intellectual 650 points

Hi Steve,

Just a few minutes ago, I was able to get to the main program while trying to debug. The steps I followed were: First I chose from the Target Configurations tab the target I wanted to launch from the specific project. Then, once I was in the debug session, I connected the target, and followed to load the program. I was finally able to step through my application. Thank you so much for your input.

Thanks,

Michelle

Processors

Processors forum

Cannot Debug