how to get TI 2A lib ?

The 2A lib is shipped as part of our DM368 IPNC reference design. You can order that from http://www.appropho.com/NewWeb/Product_DM368MT5.php#a.

Otherwise, please contact your local TI FAE or sales person to get the SW.

Regards,

Xiangdong

Hi Fu,

I have noticed appro's board. but I doubt if appro's board and its SDK is on the DVSDK 4.0.2 ?

we have get our IPNC all ready but 2A yet. all are under DVSDK 4.0.2.

local TI FAE ? the sales said no.

Yang

No, Appro's IPNC is not under DVSDK 4.0.2 yet. But you can get 2A lib from that and port it to your IPNC SW. 2A is not dependent on DVSDK or Linux kernel version at all. In fact, we highly recommend customers to start from the IPNC reference design since it is a lot more rebost and feature rich than the standard DVSDK.

Hi Fu,

thanks for your quicky reply.

We have got our IPNC working, it uses the kernel 2.6.32 and h264 encode on  DVSDK 4.0.2.  no more needed.

The IPNC works fine with some sensors with 2A built-in.

Now, we want to use mt9p006 ( mt9p031 ), this sensor needs 2A.

I have got TI 2A lib and header files, but no document. I dont' know how to use them.

Who is the local FAE?  The sales of TI chips ?

Hi Fu,

would you please tell me who is the local FAE I should contact ?

I am in china.

Yang

Hi, Xiangdong

  Are you sure the 2A lib can work in DVSDK4.0.2? We have the same question to HM Yang. We've a IPNC all work now except 2A.. But the local sales ask us to drop it and re-construct our IPCN from APPRO's referrence design, because the 2A lib cannot run in DVSDK. If that is not the truth, does anyone else succeed to use TI's 2A in DVSDK? 

Hi wang,

TI's 2A lib should be applicable in the 4.0.2. but we found it got wrong result.

So we wrote a 2A under 4.0.2.

Anyway, the 2A is rely on the TI 3A driver.

Hi Yang

  Thanks for your reply. Can you tell us more detail about the wrong result of TI's lib?  and how did you write the lib for your own, does TI provide reference code for the 3A driver? Thanks! 

Hi wang,

There is no ref code for 2A in DVSDK 4.0.2. You must get the doc about TI 3A driver to make your own 2A lib. This doc can be obtained from your supplier of the chip.

good luck !