In Wince7 about USB1 problem

Hello, I also have same issue with you above.

Do your USB1 of WINCE7 work well now? could you please guide me and share me some information about this issue?

Can you specify if you want to use the OTG port in Host mode or the pure host controller? The debug traces above show that you are using the OTG port.

AM3359 have OTG Port0 and Otg port1.  I need use the OTG port1 in Host mode.

could you please guide me? thanks a lot.

look forward your rely.

What board are you using? We tested OTG port 1 un host mode on the AM335X EVM and it works out-of-the-box. Can you compare the reference design with the one you have?

Appreciate your reply.

My  PCBA board refer to am335x_gpevm_zczbaseboard_3h0002_schematic_rev1_4a.pdf file, and I am using BSP_WINCE_ARM_A8_02_30_00_Source.exe.

as BSP_WINCE_ARM_A8_Quick_Start_Guide.pdf guide,

• AM335x EVM:
• Third Party \ BSP \ AM33X_BSP:ARMV7 \ Drivers \ MUSB
NOTE: selecting MUSB component includes OTG driver with host and function support for the port 1 and
OTG driver with host only support for the port 2.

 but as below picture, in my side, USB1 can not work.  USB0 device function work well.

could you pleae help me check again?

could you please guie me how to "Try selecting both client drivers " ?

in my VS2008 tool, I only can select below "MUSB OTG driver" item.

"MUSB OTG driver" means "BSP_USBOTG0 BSP_USBFN0 BSP_USBH0 BSP_USBOTG1 BSP_USBH1" enable.