Debug problems: load program to F25M35xx controlCard

Evgeni Kosakovski1

Hi.

I try to upload to Concerto F25M35xx controlCard demo program (one from examples). 'Build' operation is finished success. When I try to upload program to board ("Debug" operation) I received the next messages:

Cortex_M3_0: GEL Output: Memory Map Initialization Complete
Cortex_M3_0: GEL Output: Watchdog Timers Enabled
Cortex_M3_0: GEL Output: UARTs Enabled
Cortex_M3_0: Loader: One or more sections of your program falls into a memory region that is not writable. These regions will not actually be written to the target. Check your linker configuration and/or memory map.

All configuration I selected in case to F25M35xx MCU and 'Texas Instrument XDS100v2 USB Emulator', as described in "SYS/BIOS 6.33 Getting Started Guide".

What this is a problem. May be any know?

Thanks.

Evgeni.

over 12 years ago

0 ToddMullanix over 12 years ago

TI__Guru* 96960 points

Hi,

Are you talking about the demo example in the TI RTOS (also called mcusdk). If so, read section 2.2.2 in the User Guide (spruhd4a.pdf) in the mcusdk_<version>\docs directory.

You cannot use the target configuration that is included with the M3 or the C28 demo example. You need a target configuration that has both cores. In a future release we are trying to address this.

Todd