This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DM6467T BOOTME

Hello,

        After download the UBL and u-boot.bin to NAND flash, I just see "BOOTME" in hyperterminal. help me please, Thank you.

  • Hi,

    After flashing the UBL and U-bbot did you switch back to NAND boot mode ?

    Refer this link: http://processors.wiki.ti.com/index.php/DM6467_EVM_Installation#Flashing_UBL_and_U-Boot_to_NAND_using_Serial_Flasher

    Regards,

    --Prabhakar Lad

  • Hi,

        I switched the SW3 to 0001 before flashing UBL and u-boot.bin, then powered off the EVM. while I have switched the SW3 to 1110 before I power on the EVM. I am sure I have switch back it ( English is not my mother tongue, so my english... I hope you can understand my english ).

    Addison Zhang