OMAP4 - HDMI OUTPUT showing Green Noisy Screen

Green noisy screen sounds like a cable and/or connection problem between the HDMI output and the display.

Have you tried switching out new cables or new monitors?

--Jason

Hi Jason,

Complete setup (Cable, Display, firmware release..etc) is same and working on other panda board.

Check the link, http://us.generation-nt.com/answer/omap4-hdmi-phy-bug-work-around-stable-help-206586962.html

As of now I have three Panda boards with same issue, all these boards were working fine since last few months. But suddenly, HDMI Out went off (No-Signal message comes on Display screen).

-- Mihir

Hi,

Now I have four Panda boards with the same issue. HDMI output screen becomes blank. (Nothing comes on screen). It is like HDMI Out has gone bad.

Hardware: Panda ES Rev B2 (750-2170-003)

Hi Mr. Mihir,

Could you try out the http://pandaboard.org/node/13531/#debug. and let us know?

Best Regards

Feroz

Hi Feroz,

We tried this on three Panda boards (let's say A, B and C) on which HDMI Out problem is present

The A board was giving Green screen and noisy test pattern results. While the B and C boards don't detect the HDMI port (Display shows "No Signal").

Regards,

Mihir