DM355 RBL

Kenric Smith

Does the DM355 RBL issue a NAND RESET command before doing any reads? The new Micron parts require a RESET command before any other commands.

over 12 years ago

0 Chandrashekar Ishwaramangala Ganeshrao over 12 years ago

TI__Intellectual 2370 points

Hi Smith,

http://processors.wiki.ti.com/index.php/List_of_NANDs_devices_supported_by_TI_RBLs#DM335.2F355

Check this link for Supported Nand In RBL for Dm355 processor. This would tell if new Micron parts are tested and their requirements are met in RBL

0 Kenric Smith over 12 years ago in reply to Chandrashekar Ishwaramangala Ganeshrao

Prodigy 100 points

The part is not on that list, but very similar part numbers are. This part was already tested and the DM355 does boot from it. The manufacturer's data sheet says that the RESET command must be the first command issued, so I need to know if the RBL issues that command before doing any reads.

Kenric

Processors

Processors forum

DM355 RBL