SGX, GPU Compositing for DM8168

Gabi Gvili

Hi All,

At the post here

http://e2e.ti.com/support/dsp/omap_applications_processors/f/447/p/157222/825324.aspx#825324

Prabindh Sundareson says: "glTexImage2D is not the recommended way to draw textures. For the right way, check the below.

http://processors.wiki.ti.com/index.php/GPU_Compositing", is the content of this wiki page works also for DM8168? Are there any adjacent needed to be done?

Thanks,
Gabi

over 12 years ago

0 Margarita Gashova over 12 years ago

TI__Guru* 80190 points

Hello,

I am not familiar with Graphics SDK, but

you could try to follow:

http://processors.wiki.ti.com/index.php/GPU_Compositing

and build the Graphics SDK as per the instructions in the Graphics SDK User Guide for TI816x.

http://processors.wiki.ti.com/index.php/Graphics_SDK_Quick_installation_and_user_guide

Best Regards,

Margarita

0 Gabi Gvili over 12 years ago in reply to Margarita Gashova

Genius 4120 points

Hi Margarita,

Thanks for your answer, I am familiar with those wiki pages.
I have problems while trying to follow instructions in the GPU_Compositing wiki page, it seems that the graphics-sdk_4.04.00.02 that comes with EZSDK 5.05 can not be compiled with the composition, thus installing of graphics-sdk_4.06.00.03 is required, but after installation of graphics-sdk_4.06.00.03 the target fails in running
pvr_init start (EGL init failure).
Another problem is that even though i am following the instructions for compiling gpuvsink, when running ./autogen.sh the following error occur:

configure.ac:87: required file `src/Makefile.in' not found
autoreconf: automake failed with exit status: 1
autogen.sh failed

Thanks,
Gabi

Processors

Processors forum

SGX, GPU Compositing for DM8168