AM335x CPSW Ethernet queries

K Md Feroz Irfan

Expert 7225 points

Other Parts Discussed in Thread: AM3352

Hi Team,

Need your inputs on the below queries: I have put in some comments too. Kindly ratify.

We found Most of the TI’s development kit ICE kit, beagle bone board has routed Ethernet functionality via PRU’s – But we haven’t seen any application notes, using AM3352 were Ethernet switch functionality has been used MII lines. Please provide sufficient evidence on this?

Any test code to check MII interface
Ethernet switch configuration process

Best Regardfs

Feroz

over 12 years ago

0 peaves over 12 years ago

TI__Guru 62855 points

The BeagleBone has a MII Ethernet PHY connected to CPSW. The AM335x Starter Kit has two RGMII Ethernet PHYs connected to CPSW.

Regards,
Paul

0 K Md Feroz Irfan over 12 years ago in reply to peaves

TI__Expert 7225 points

Thanks Paul,

So these are not being routed via PRU on these non-industrial boards??? Alright!

How about the MII test code and switch config ? Any pointers here?

Thanks & Best Regards

Feroz

0 peaves over 12 years ago in reply to K Md Feroz Irfan

TI__Guru 62855 points

I provide hardware support and not the best person to answer software questions. However, your seperate email sent on Tuesday 3/12/2013 seems to indicate you already provided the customer with references to diagnostics code and the CPSW driver documentation.

Regards,
Paul

Processors

Processors forum

AM335x CPSW Ethernet queries