Developing StarterWare on BeagleBone Black

Liz

Other Parts Discussed in Thread: TMDXEVM3358

Hi,

Just got my BB Black. Looks very nice. But without a JTAG, how do I do development for StarterWare? I am a SW folk and I don't want to do soldering...

Thanks

over 13 years ago

0 Satyaprakash Mishra over 13 years ago

Intellectual 815 points

Liz

I think BeagleBone Black should have on-board usb emulator. If not it must have JTAG Header on board.

I have attached a specification doc, i hope you have that one plz go through that.

Can you check board specification from .

http://circuitco.com/support/index.php?title=BeagleBoneBlack

http://beagleboard.org/Products/BeagleBone%20Black

http://www.element14.com/community/docs/DOC-54121/l/circuitco-beaglebone-black-development-platform-based-on-ti-sitara-am3358-processor

Thanks

BBB_SRM.pdf

0 MaciejKucia over 13 years ago in reply to Satyaprakash Mishra

Mastermind 7925 points

Satyaprakash Mishra said:
I think BeagleBone Black should have on-board usb emulator. If not it must have JTAG Header on board.

There is no on-bard emulator. JTAG header must be soldered just as OP said.

Regards,
Maciej

0 Chris Yorkey over 12 years ago in reply to MaciejKucia

TI__Genius 16340 points

Fellow Users,

Just to clarify in case an RMA is ever needed:

For Sitara BeagleBoards (BeagleBone BeagleBone Black) use:

http://beagleboard.org/support/RMA

For Sitara EVMs (TMDXEVM3358, TMDXIDK3359, TMDXICE3359) use:

http://circuitco.com/wordpress/rma/

Hope this helps!

-Chris

Processors

Processors forum

Developing StarterWare on BeagleBone Black