OMAP3530 ISP camera Usage

samuthira pandian

Other Parts Discussed in Thread: OMAP3530

Hi all,

I am using cm-t3530 processor for my application development. In my application i am going to use camera ISP interface. I am using Linux-3.0.68 kernel. I have configured the kernel with Camera ISP support option. Now i don't know how to access the camera in my application. Also below i have mentioned my camera interface configuration. So kindly tell me how to use the camera in my application.

1. The camera sensor sony 1CX659ALA which is connected to the AFE (Analog Front End) chip. The chip is capture the Analog signal and converted to Digital signal. The Signal is directly connected to the Processor Cameara data Lines ( D2 - D13).

Regards,

Sam

over 12 years ago

0 Cvetolin Shulev-XID over 12 years ago

TI__Guru 65405 points

Hi Samuthira,

The first and most important thing is to initialize the camera sensor. As you have made configure the kernel with camera ISP support option and add the proper camera driver. Then you could use the video for linux (v4l2) to manage the camera input stream. For some details about configuration and performance limits you can refer to TRM chapter 12 Camera ISP at the link below:

http://www.ti.com/lit/ug/spruf98x/spruf98x.pdf

Tsvetolin Shulev

0 samuthira pandian over 12 years ago in reply to Cvetolin Shulev-XID

Prodigy 80 points

Hello Tsvetolin Shulev,

Thank you for your reply. The spruf98x.pdf document is corrupted in the mentioned path ( http://www.ti.com/lit/ug/spruf98x/spruf98x.pdf). Where else i can get the document. kindly guide me how to configure the camera ISP.

Thanks

Sam

0 Cvetolin Shulev-XID over 12 years ago in reply to samuthira pandian

TI__Guru 65405 points

Hi Samuthira,

If you can not open the link above you could try the omap3530 processor link below

http://www.ti.com/product/omap3530

and open Technical reference guide link.

Tsvetolin Shulev

Processors

Processors forum

OMAP3530 ISP camera Usage