About 8127 sensor

_{Hi Jack Jack2,}

_{There are 2 stuffs you need to consider when you change the sensor.}

• _{First, check your sensor driver configuration for width and height.}
• _{Check your usecase. If you use full feature mode/capture display mode or any other,  go to corresponding ".c" file located in src_linux/mcfw_api/usecases/ directory and change capture/camera parameters.}
  
  

Thank you for you reply!I have sloved that problem.But now I have a new proble.I took a picture as follow:

Correct picture as follows:

Do you konw why?

Hi Jack,

By observing your picture, the issue may be related to quality. So you have to tune your sensor using ITT/DCC. 

(Assuming you use similar configuration which used by mt9j003, for all your bit depth configs and format configs.)

Hi Ravikiran,

I use the ITT software,but it always crash when I want to get an image!How can I do?

Hi jack,

Please make sure that, you are using the correct version of ITT?DCC. please go through the document provided with the ITT package in GA release.
Same ITT works on my PC without much issues.

1. Install ITT on your PC
2. Note down your IPNC ipaddr.
3. after booting, open DCC, slelect RAW or YUV capture option. don't forget to give correct ip to the tool. 
4. Select suiatable file name and press save.
5. Now you should be able to see the raw / yuv image saved.

I use the GA release version 3.0 and Image Tuning Tool Version 1.0.0.It provided with the ITT package in GA release. When I did step 4 of what you said ,It crushed.I am sure that the ipaddr is right.

Is there a connection button in itt software? I can't see it in this version.

Oh,thank you for Ravikiran again ,I reinstall the  Microsoft .NET Framework 4 ,and it ok now!