Question about Dm8168 caputure HD signal with a offset

Away.liu

When i use 8168(DVRRDK3.5 platform) capture Hd signal such as 720P/1080P , i found a question . Question about Dm8168 caputure HD signal with a offset

over 12 years ago

0 Away.liu over 12 years ago

Intellectual 890 points

0 Brijesh Jadav over 12 years ago

TI__Guru**** 481095 points

Hi,

Could you please tell what is the input interface from your decoder to VIP?

Regards,

Brijesh Jadav

0 Away.liu over 12 years ago in reply to Brijesh Jadav

Intellectual 890 points

Hi:

I use Vip0-16bit to capture HD signal ( DVI) and encode H264.

When i use Vip1-8bit ,this issue still alive.

0 Brijesh Jadav over 12 years ago in reply to Away.liu

TI__Guru**** 481095 points

Is it the embedded sync format or discrete sync?

0 Away.liu over 12 years ago in reply to Brijesh Jadav

Intellectual 890 points

The embedded sync format.

0 Away.liu over 12 years ago in reply to Away.liu

Intellectual 890 points

Looking forward to getting some advices...

0 Brijesh Jadav over 12 years ago in reply to Away.liu

TI__Guru**** 481095 points

Hi,

Can you please check if enableSdCrop flag is enabled? can you check the pitch in the capture link?

Can you please tell me the platform and its revision you are using?

Regards,

Brijesh Jadav

0 Away.liu over 12 years ago in reply to Brijesh Jadav

Intellectual 890 points

Hi Brijesh:

It is ok now, thank you very much!

0 Brijesh Jadav over 12 years ago in reply to Away.liu

TI__Guru**** 481095 points

What was the problem?

0 Away.liu over 12 years ago in reply to Brijesh Jadav

Intellectual 890 points

The program run to crop mode. Disable it now..

Processors

Processors forum

Question about Dm8168 caputure HD signal with a offset