Leopard DM368 with dual camera module

Martin Koutny

Other Parts Discussed in Thread: DM385

Hi Jethin,

nice! I need less fps. I am little bit lost. Could you provide me a liite help? I am using Leopard DM368 with dual camera module. Where did you take a driver and other sw for enabling of IPNC?

Martin

over 13 years ago

0 Jethin Sekhar over 13 years ago

Expert 1130 points

Dear martin

I am not familiar with your driver realted stuffs, but i can point you out in sensor settings, if you share me exact requirement

Regards

Jethin

0 Martin Koutny over 13 years ago in reply to Jethin Sekhar

Prodigy 130 points

Jethin,

thank you. Now I have this: https://www.leopardimaging.com/uploads/LI-M024DUAL.pdf and Leopard board 368. It use MT9M034. It works now perfectly. There is TI SW preinstalled so I can login to IE window, take a video etc.

My idea is to take a single stream 1920x1080@H.323, with 30fps for its processing on the board with openCV. So I don't need the IPNC, the Active X control etc.

Regards

Martin

0 Jethin Sekhar over 13 years ago in reply to Martin Koutny

Expert 1130 points

matin,

Mt9m034 wont support 1080p, i can support only upto 1280 x 960

Jethin

0 Martin Koutny over 13 years ago in reply to Jethin Sekhar

Prodigy 130 points

Jethin, the resolution I can see is 1920x1080. SW Versionis DM368 IPNC REF Design 2.60.00. I got a driver from Leopard but I am not sure. Can we move to email conversation? I cannot send a prive message to you.

0 hongbing luo over 12 years ago in reply to Martin Koutny

Prodigy 10 points

dm385?

0 Brian Ramos over 11 years ago in reply to Martin Koutny

Prodigy 10 points

Hi Martin,

I just received my LI-M024DUAL and Leopard board 368 and I'm not sure how to get it up and running. Can you point me in the right direction? The Leopard Imaging website doesn't seem to have any info on software. How did you get it working?

- Brian

0 Martin Koutny over 11 years ago in reply to Brian Ramos

Prodigy 130 points

Hi Brian,

sorry for delay. Did you solve it? After connection DM368 and LI module there is a web page for setting of the camere.

The problem is, that only IE6.

Martin

0 Biser Gatchev-XID over 11 years ago in reply to Martin Koutny

TI__Guru**** 393215 points

Martin, Brian,

You are in the wrong forum. The correct place for DM368 discussions is http://e2e.ti.com/support/dsp/davinci_digital_media_processors/f/100.aspx. I'm going to split this thread and move it to the correct forum.

Processors

Processors forum

Leopard DM368 with dual camera module