CCS3.3 with OMAPL137EVM

WRS

Other Parts Discussed in Thread: CCSTUDIO, OMAP-L137

I am trying to debug OMAPL137EVM dsp with CCS3.3, OMAPL137 has an embedded JTAG port ( XDS 510) and I successfully install

the driver( could see the device in device manager), but in CCS setup there are no OMAPL137 configurations, what step did I miss ?

Thanks.

over 16 years ago

0 Mariana over 16 years ago

TI__Mastermind 24340 points

Are you using the full version of CCS?

If you are you can get the drivers from the page:

http://support.spectrumdigital.com/ccs33/

If the configuration does not appear in the CCSsetup after that, you can get the .ccs files at:

http://support.spectrumdigital.com/boards/evmomapl137/revd/

under EVMOMAPL137 Software Resources, see EVMOMAPL137 CCS Config Files

I would suggest you put the files at:

C:\CCStudio_v3.3\drivers\import

If they still do not show there, you can go to CCSsetup and go to File-> Import and point to the .ccs files for OMAP-L137.

Also, make sure that you have SR12 as the GSG suggests.

0 Prathap Srinivas over 16 years ago in reply to Mariana

TI__Expert 5000 points

Can you run CCSSetup and import the .ccs file required as suggested by Mariana.Also make sure you save this configuration before you exit the CCSsetup.

Thanks,

Prathap.

0 WRS over 16 years ago in reply to Mariana

Prodigy 185 points

Thanks very much, now I can connect and debug dsplink. But on OMAPL137, every time dsp generates a interrupt (using loop sample)

to ARM, the OS running on ARM hangs. Specifically the loop sample will call HAL_intSend, after that dsp continue running, but ARM dies,

I checked the code the interrupt handler is properly connected, I triggered the interrupt on ARM side and ISR works fine. Do you have any

idea on this ?

Processors

Processors forum

CCS3.3 with OMAPL137EVM