Hi,
I have one question.
My customer uses WEC7BSP with AM3874. And my customer uses "set_device_power" function.
This function turns on/off LCD's backlight. My customer calls this function in before/after ResetDSS.
But customer's system hangs up sometimes when power on sequence. The failure rate is very rarely.
So customer changed from using the "set_device_power" function to directly register setting. As a result, this failure was gone.
So I would like to know the set_device_power function. Are there any limitation for "set_device_power" function?
Please advise me. I appreciate your quick reply.
Best regards,
Michi