DM644x initialization passed!
TI UBL Version: 1.50
Booting Catalog Boot Loader
BootMode = NAND
Starting NAND Copy...
Valid magicnum, 0xA1ACED66, found in block 0x00000006.
DONE
Jumping to entry point at 0x81080000.
U-Boot 1.2.0 (Apr 13 2009 - 12:08:08)
I2C: ready
DRAM: 256 MB
unknown vendor=0 Flash: 0 kB
NAND: NAND device: Manufacturer ID: 0xec, Chip ID: 0x36 (Samsung NAND 64MiB 1,)
64 MiB
In: serial
Out: serial
Err: serial
ARM Clock :- 297MHz
DDR Clock :- 162MHz
MSP430 Firmware supports AM/PM Feature
Hit any key to stop autoboot: 0
DaVinci EVM # DM644x initialization passed!
TI UBL Version: 1.50
Booting Catalog Boot Loader
BootMode = NAND
Starting NAND Copy...
Valid magicnum, 0xA1ACED66, found in block 0x00000006.
DONE
Jumping to entry point at 0x81080000.
U-Boot 1.2.0 (Apr 13 2009 - 12:08:08)
I2C: ready
DRAM: 256 MB
unknown vendor=0 Flash: 0 kB
NAND: NAND device: Manufacturer ID: 0xec, Chip ID: 0x36 (Samsung NAND 64MiB 1,)
64 MiB
In: serial
Out: serial
Err: serial
ARM Clock :- 297MHz
DDR Clock :- 162MHz
MSP430 Firmware supports AM/PM Feature
Hit any key to stop autoboot: 0
Loading from NAND 64MiB 1,8V 8-bit, offset 0x200000
Image Name: Linux-2.6.18_pro500-davinci_evm-
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2018280 Bytes = 1.9 MB
Load Address: 80008000
Entry Point: 80008000
## Booting image at 80700000 ...
Image Name: Linux-2.6.18_pro500-davinci_evm-
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2018280 Bytes = 1.9 MB
Load Address: 80008000
Entry Point: 80008000
Verifying Checksum ... OK
OK
Starting kernel ...
Uncompressing Linux.............................................................
then gets hanged...
plz give me some hints to reboot the nand flash with kernel image..