Restore device

Slava Muzychko

Hi.

I tried update U-boot and kernal for am335x.

After reboot i got message:

U-Boot SPL 2013.01.01 (Jun 25 2013 - 16:42:52)
Could not probe the EEPROM; something fundamentally wrong on the I2C bus.
Could not get board ID.
Could not probe the EEPROM; something fundamentally wrong on the I2C bus.
I2C read: I/O error
Could not read the EEPROM; something fundamentally wrong on the I2C bus.
I2C read: I/O error
Could not read the EEPROM; something fundamentally wrong on the I2C bus.
### ERROR ### Please RESET the board ###

Is it possible restore device?

over 11 years ago

0 Miroslav Kiradzhiyski XID over 11 years ago

TI__Mastermind 25235 points

Hi Slava,

Does your board have an on-board EEPROM chip?

Best regards,
Miroslav

0 Slava Muzychko over 11 years ago in reply to Miroslav Kiradzhiyski XID

Prodigy 60 points

No.

My board VAR-SOM-AM33.

0 Miroslav Kiradzhiyski XID over 11 years ago in reply to Slava Muzychko

TI__Mastermind 25235 points

Then you will need to workaround the EEPROM dependencies. Take a look at this thread, where this has already been discussed: http://e2e.ti.com/support/arm/sitara_arm/f/791/p/297989/1038791.aspx

Best regards,
Miroslav

0 Slava Muzychko over 11 years ago in reply to Miroslav Kiradzhiyski XID

Prodigy 60 points

I can rebuild u boot but how load him after this error?

0 Miroslav Kiradzhiyski XID over 11 years ago in reply to Slava Muzychko

TI__Mastermind 25235 points

Depends on where you are booting from. SD card? NAND flash? Network?

Best regards,
Miroslav

0 Slava Muzychko over 11 years ago in reply to Miroslav Kiradzhiyski XID

Prodigy 60 points

I restored from SD card.

Thanks!

Processors

Processors forum

Restore device