OMAPL138 PMIC

Amit Khanna

Other Parts Discussed in Thread: TPS65910, TPS650006, OMAPL138, OMAP-L138, TPS650061

I am using OMAPL138 processor. What PMIC part does TI recommend for it that satisfies power and sequencing requirements? Is there a high reliability version of this part? I found these on the website: TPS65070RSL, TPS650250RHBR, TPS650006, TPS65910. I am not sure which one fits OMAPL138 better.

over 9 years ago

0 Titusrathinaraj Stalin over 9 years ago

TI__Guru** 116100 points

You can refer our OMAPL138 LCDK board schematics for PMIC part.

http://processors.wiki.ti.com/index.php/OMAPL138_SW_%26_HW_Comparison

http://processors.wiki.ti.com/index.php/OMAP-L138_LCDK_Schematic_Companion

http://processors.wiki.ti.com/index.php/L138/C6748_Development_Kit_%28LCDK%29

0 Senthilkumar Srinivasan over 9 years ago

TI__Mastermind 43660 points

Hello Amit,

TI recommends to use TPS650061 for powering the OMAPL138 device. You can refer the below document for more details.

http://www.ti.com/lit/an/slva513/slva513.pdf

Regards,

Senthil

0 Amit Khanna over 9 years ago in reply to Senthilkumar Srinivasan

Prodigy 200 points

Thanks both Titus and Senthil. I looked at multiple PMIC offered by TI. The TPS650061 is a good fit. However, it doesn't provide enough margin for my application on the load current requirement of the OMAPL138. In addition the power sequencing is controlled externally by adding more circuitry to provide delay and provide enables. I will more likely use the TPS65910A1RSL. It also provides application guide for powering OMAPL138. It has enough power margins and has built in power sequencing.

0 Senthilkumar Srinivasan over 9 years ago in reply to Amit Khanna

TI__Mastermind 43660 points

Hello Amit,

Yes, you can use TPS65910A1RSL PMIC for powering OMAPL138. If you have any question about the interconnection between TPS65910 and OMAPL138, feel free to post query in power management forum. They will help you better.

Regards,
Senthil

Processors

Processors forum

OMAPL138 PMIC