C6748 USB BULK EXAMPLE

Dhar Kurban

Intellectual 960 points

I am running the USB Bulk Example on a C6748 Eval board. I need the Windows Host Application to test it.

Originally this was located at the StellarisWare link shown on this page:

This link appears to no longer exist.

Does anyone know where I can find the Host Bulk Application?

Thanks

over 10 years ago

0 Norman Wong over 10 years ago

Guru 26430 points

Recent thread about much the same subject here:
e2e.ti.com/.../400362

www.ti.com/.../sw-usb-windrivers
StellarisWare embedded USB drivers
SW-USB-windrivers-6459.zip

www.ti.com/.../sw-usb-win
StellarisWare® Windows-side USB examples
SW-USB-win-9107.msi

0 Shankari G over 10 years ago

TI__Mastermind 43955 points

Hi Dhar,

As per Norman suggestion, you can take up the Windows Host apllication.

For Starterware link please refer to

I have tested this link, it works for me!!...Please recheck

If you are still not able to find the Windows host application please revert.

Regards,

Shankari

-------------------------------------------------------------------------------------------------------

Please click the Verify Answer button on this post if it answers your question.
--------------------------------------------------------------------------------------------------------

0 Dhar Kurban over 10 years ago in reply to Norman Wong

Intellectual 960 points

Thanks Norman.

In the section where it describes how to run the example it has this line

"Note: The bulk class is configured and tested for Full-Speed PIO mode only"

It appears that is done in one of the supplied libraries.

Any idea if we can change this to Hi-Speed?

Thanks

0 Norman Wong over 10 years ago in reply to Dhar Kurban

Guru 26430 points

See Walter's thread here:
e2e.ti.com/.../401858

0 Dhar Kurban over 10 years ago in reply to Norman Wong

Intellectual 960 points

Answer: The following simple change to usbdbulk.c

unsigned char g_pBulkDeviceDescriptor[] =
{

18, // Size of this structure.
USB_DTYPE_DEVICE,
USBShort(0x200), // was USBShort(0x110) This change will report the USB version as 2.0
....

I am assuming that file is used in the usblib.lib

Processors

Processors forum

C6748 USB BULK EXAMPLE