Running a standalone SYS/BIOS application on DM8148

debasish saha1

Hi,

I want to run a SYS/BIOS application on ARM platform in DM8148 for a project. I dont want to use JTAG for dumping the code in A8 core. I want a stand alone SYS/BIOS application which will run on A8 without using CCS and JTAG.

Is any document or link available for that? Any help will be appreciated.

Regards,

Debasish

over 10 years ago

0 Pavel Botev over 10 years ago

TI__Guru**** 170625 points

Hi Debasish,

Please refer to the Bios_Getting_Started_Guide.pdf, section: 1.8 Using SYS/BIOS as a Standalone Product

processors.wiki.ti.com/.../BIOS_FAQs

BR
Pavel

0 debasish saha1 over 10 years ago in reply to Pavel Botev

Intellectual 920 points

Hi Pavel,

Thanks for the reply. But I want to know how to run the standalone SYS/BIOS application in DM8148 EVM. What is the bootloader I should use? where I can get these packages?

If I want to flash my application in SD card or SPI flash, how it should be done so that my SYS/BIOS application starts automatically after I power on my board.

Regards,

Debasish

0 Pavel Botev over 10 years ago in reply to debasish saha1

TI__Guru**** 170625 points

Debasish,

Please use our SYS/BIOS forum regarding SYS/BIOS questions.

BR
Pavel

Processors

Processors forum

Running a standalone SYS/BIOS application on DM8148