DM6437 ndk socket problem, please

chengshiun lee

Prodigy 20 points

Hi,

I am looking for an example of a simple UDP client to run under NDK and the files about ndk1.92 full.

I have been trying an example about Use Sockets Programming APIs where I found in this PDF page 74.

I couldn't find the sender.c and addToClient_starter.c in my ndk 1.92.

Can someone give me the files about ndk1.92 or just tell me how to finish this example or where am I wrong.

Thanks.

Jeffrey

over 10 years ago

0 ScottG over 10 years ago

TI__Mastermind 26780 points

Jeffrey,

The source code for these labs at this link mentioned in the abstract: www-s.ti.com/.../spraax4.zip

Regards,
Scott

0 chengshiun lee over 10 years ago in reply to ScottG

Prodigy 20 points

Scott,

Thanks for helping me.

My board is DM6437, your solution is about C6455.

I still don't know how to setup the ndk file in my case.

The program you gave me uses the library of csl, but my board is not support to the files about csl.

Therefor, do you have the example solution or the library files like csl that can be used for DM6437 ?

Thanks,

Jeffrey

0 ScottG over 10 years ago in reply to chengshiun lee

TI__Mastermind 26780 points

Jeffrey,

No, I don’t see other examples or HAL libraries to replace the CSL calls used in those labs. From the description in the introduction section, it seems you can use the exact same NDK code used by the labs on the DM6437 too, but you’ll need to implement the HAL support to get them running on the DM6437. Sorry to not have a better answer for you.

Scott

Processors

Processors forum

DM6437 ndk socket problem, please