Flashing U-Boot from U-Boot

Balaji Govindarajan

Dear sir,

I have tried chapter 1.5.2 Flashing U-Boot from UBoot (DM8168 DVR RDK Install Guide) using the TFTP server. After followed 1.5.2.1 step, I cannot able to see any display on Teraterm. Using EMAC Boot, also same problem. How to recover from this issue? Can you mail me in detail so that it will be easy for me to go ahead

Regards

Balaji

over 10 years ago

0 Balaji Govindarajan over 10 years ago

Expert 2315 points

I fixed above issue. I can load uboot and uImage but system is handing (D11 led is red not blinking). I have attached log file.

0 Pavel Botev over 10 years ago in reply to Balaji Govindarajan

TI__Guru**** 170625 points

Balaji,

I am not familiar with DVR RDK. For DVR RDK specific questions, you should contact your local FAE, see the below post:
e2e.ti.com/.../224844

In general, the DVR RDK use PSP beneath. To flash u-boot from u-boot you can refer to the below wiki page:

processors.wiki.ti.com/.../TI81XX_PSP_UBOOT_User_Guide

Regards,
Pavel

Processors

Processors forum

Flashing U-Boot from U-Boot