Ball Characteristics in AM437x Datasheet

Kanae

Guru 10295 points

Hi all,

I would like to make sure the reason why it describes

– Z "or OFF": High-impedance in the datasheet; 4.2 Ball Characteristics

6. BALL RESET STATE and 7. BALL RESET REL. STATE.

AM335x Datasheet describes "– Z : High-impedance" that is not included "or OFF".

Is there any reason that it makes point to "or OFF" in AM437x Datasheet?

Best regards,
Kanae

over 11 years ago

0 Biser Gatchev-XID over 11 years ago

TI__Guru**** 393215 points

Hi,

This is simply the way ball state is marked in the table. There is no correlation to AM335X datasheet.

0 Kanae over 11 years ago in reply to Biser Gatchev-XID

Guru 10295 points

Hi Biser,

Thank you for your quick reply.
I think that "Z" and "OFF" means "High-impedance",
so why does it use "OFF" in the table instead of "Z"?

Best regards,
Kanae

0 Biser Gatchev-XID over 11 years ago in reply to Kanae

TI__Guru**** 393215 points

I don't know and I don't think this has any significance. Yes, they both mean high impedance.

0 Biser Gatchev-XID over 11 years ago in reply to Biser Gatchev-XID

TI__Guru**** 393215 points

You can use the "Submit documentation feedback" link at the bottom of each page of the PDF document to contact the documentation team directly.

0 Kanae over 11 years ago in reply to Biser Gatchev-XID

Guru 10295 points

Hi,
Thank you for your reply to my tedious question.
I need to know to explain to my customer.
I understand it does not especially mean anything by using "OFF".

Best regards,
Kanae

Processors

Processors forum

Ball Characteristics in AM437x Datasheet