CC2530 Compatibility Issues

Aashish Khairnar26

Intellectual 300 points

Other Parts Discussed in Thread: CC2530, CC2530EM

Are there any compatibility issues when we interface AM335x based BBB with CC2530 through UART?

over 9 years ago

0 Biser Gatchev-XID over 9 years ago

TI__Guru**** 393215 points

Hi,

There should be no hardware issues. The BBB peripherals are powered from 3.3V.

0 Aashish Khairnar26 over 9 years ago in reply to Biser Gatchev-XID

Intellectual 300 points

Hi Biser
Sir we already discussed this issue on
e2e.ti.com/.../1613305 .

Please go through it so that you can get what I'm trying to say.
We were able to interface CC2530EM using SmartRF05 1.8.1 by doing normal UART connections(Rx, Tx, Vcc, Gnd). But when we tried to interface CC2530EM directly with BBB, we were unable to establish connection. So were are out of any ideas.

Regards,
Aashish Khairnar

0 Biser Gatchev-XID over 9 years ago in reply to Aashish Khairnar26

TI__Guru**** 393215 points

From your other post I see that you are not able to reset the module. Is this correct? Have you connected the module reset signal to BBB?

0 Aashish Khairnar26 over 9 years ago in reply to Biser Gatchev-XID

Intellectual 300 points

Hi Biser,
No sir, we didn't connected reset sigtnal to BBB.
But sir when we connect it through SmartRF05 board then also reset is not connected and it is working.
Regards,
Aashish Khairnar

0 Biser Gatchev-XID over 9 years ago in reply to Aashish Khairnar26

TI__Guru**** 393215 points

I'm afraid we cannot help you on this forum. Your questions are about the CC2530 and we have no experts on this here. I suggest you continue on the other forum.

0 Aashish Khairnar26 over 9 years ago in reply to Biser Gatchev-XID

Intellectual 300 points

Ok Sir, I will look on that forum only for answer.
Thank you.

Regards,
Aashish Khairnar

Processors

Processors forum

CC2530 Compatibility Issues