Smart RF programmer in Linux

Bharath Atreya40

We are trying to use Smart RF Programmer in Linux using wine.

We are unable to see the XDS 100 debugger to show up on this. Are there any steps to be followed to get the Smart RF programmer app to talk to the debugger?

over 9 years ago

0 Titusrathinaraj Stalin over 9 years ago

TI__Guru** 116100 points

Dear Bharath,
You can use the following forum to post your low power tool (smart RF programmer)
e2e.ti.com/.../155

Able to detect the XDS100 debugger on linux through CCS IDE ?

After CCS installation, please run the following scripts.

/opt/ti/ccsv5/install_scripts/install_drivers.sh
/opt/ti/ccsv5/install_scripts/ti_xds100_linux_install.sh

Processors

Processors forum

Smart RF programmer in Linux