DM368 questions

John J Wu

Genius 3870 points

Do you know DM368 signal latency for 1080p, 30fps and 60fps H.264 encode and decode?

Also, do you have additional information regarding bit rates? Thanks.

0 Yashwant Dutt over 15 years ago

Hi,

DM368 supports 1080P@30fps encode and closed loop decode. It does not support 1080p@60fps.

Though it can support bitrate as defined by level limits, you may see slignt perfromance degardation if you cross 15mbps.

Some latency info can be found in the below FAQ -

regards

Yashwant

0 John J Wu over 15 years ago in reply to Yashwant Dutt

Genius 3870 points

Thanks a lot Yashwant. The FAQ covers latency for DM365. Does it (33ms) apply to DM368?

Best.

0 Yashwant Dutt over 15 years ago in reply to John J Wu

Yes, it is applicable to DM368 also. Current latency is 33ms for codec.

Ver 2.0 release which is sceduled in June end will reduce it to sub 5ms.

regards

Yashwant

0 gomo over 15 years ago in reply to Yashwant Dutt

Genius 3400 points

I'm also care of the performance of JPEG code In Ver 2.0. And more attention to 5M YUV code to JPEG especially.

Thanks!

0 Immanuel Rathinam over 14 years ago in reply to gomo

Yashwant,

Is 2.0 release is available now and sub 5ms latency is possible?

Regards, Imman

0 Yashwant Dutt over 14 years ago in reply to Immanuel Rathinam

regards

Yashwant.

Processors forum