Newbie: Cannot Connect to Target TMS320C6678 Evaluation Module

joe lindula

Other Parts Discussed in Thread: TMS320C6678

Hello, when I try to connect to the TMS320C6678 in Debug mode for the C6678 Eval Module I get the following error:

I am able to run the Sd560Cnfgv5 tool and it does see that one emulator is attached.

This is my very first Code Composer project. Is there some tests that I can do to help me? Is it possible to upload my project?

Thanks,

Joe

over 10 years ago

0 Senthilkumar Srinivasan over 10 years ago

TI__Mastermind 43660 points

Joe,

Are you using external XDS560 emulator ? Have you tried connecting the target using on board emulator ?
Have you created a target configuration and could able to pass the test connection ?

Regarding software, you could see all the relevant information in the below link.

www.ti.com/.../tmdsevm6678

Regards,
Senthil

0 joe lindula over 10 years ago in reply to Senthilkumar Srinivasan

Mastermind 6940 points

Senthil,

Hello, thanks for responding to my post. I have not tried "Have you created a target configuration and could able to pass the test connection" and do not know how that is done. I will look into that. Also, I do not know how to "Have you tried connecting the target using on board emulator ". I have only connected the external XDS560v2 Pro Trace Emulator to the EVM board. My co-worker has a XDS560v2 STM emulator that I could try.

This is a whole new world for me. Thanks for all your help. Joe