Face Detection support in DM368 or DM365

Navin Prashath

How to find whether my DM368 or DM365 supports Face Detection?In many posts they have mentioned that there will be suffix 'F.How to find without knowing full processor name?

over 9 years ago

0 Prabhakar Lad over 9 years ago

Guru 11260 points

Hello,

For a quick hack , try reading the address 0x01c71800 (memory map it and read it) which is FDIF_PID [1] (page 34), and then write some value into it (0-7 bits) and read it back again. check if value has changed (1st-7 bits)

[1] www.ti.com/.../sprugg8a.pdf

Cheers,
--Prabhakar Lad

0 Navin Prashath over 9 years ago in reply to Prabhakar Lad

Intellectual 760 points

Hi Prabhakar,
The value is not getting changed.The value is 0.So I hope face detection module is not present in my board.Thanks for the quick reply.
Regards,
Navinprashath.R.R

0 Navin Prashath over 9 years ago in reply to Navin Prashath

Intellectual 760 points

Hi Prabhakar,
Is there any other way to make sure that the FD module is not present?
Regards,
Navinprashath.R.R

0 Navin Prashath over 9 years ago in reply to Navin Prashath

Intellectual 760 points

What is the DEV_FEATURE Register address in DM365 or DM368?

Processors

Processors forum

Face Detection support in DM368 or DM365