"TMS320C5535 CSL/ADC" unable to find ADC module.

das m

Other Parts Discussed in Thread: TMS320C5535

TMS320C5535 support ADC?

Hi All, in 5535 eZdsp .. c55xx_csl\ccs_v4.0_examples folder location i am unable to find the adc(Analog to Digital ) folder. I suppose perform ADC operation to call the ADC_setFreq(), ADC_read(). while compile above two function is not support because i don't have supported adc header file inside csl. Can you please help how to get(from where i can down load) adc folder or file csl_adc.h

@@@@

over 9 years ago

0 das m over 9 years ago

Prodigy 20 points

SAR folder supprt ADC functionality ?

0 Vasantha K over 9 years ago

TI__Genius 12575 points

Hi,

Take a look at SAR folder.

Regards

Vasanth

0 Vasantha K over 9 years ago in reply to Vasantha K

TI__Genius 12575 points

Hi,

The SAR is a 10-bit ADC using a switched capacitor architecture that converts an analog input signal to a digital value at a maximum rate of 64 ksps for use by the DSP. This SAR module supports multiple channels that are connected to four general purpose analog pins (GPAIN [3:0]), which can also be used as general-purpose digital outputs.

From your previous post, I understand that you were looking for functions like setting the frequency, Reading converted values etc. There are SAR CSL examples which will guide you further on this. Hope it helps.

Regards

Vasanth

Processors

Processors forum

"TMS320C5535 CSL/ADC" unable to find ADC module.