Uploading bit file to FPGA over EMIFA Example C6747

J L75

Other Parts Discussed in Thread: OMAP-L138, OMAP-L137

HI all,

I'm a bit new to this, but I was wondering if there was a relatively simple (and up-to-date) example on how to program a Xilinx FPGA from a bitfile connected to the EMIFa on my C6747 microcontroller?

Thank you

over 9 years ago

0 Sivaraj Kuppuraj over 9 years ago

TI__Mastermind 35645 points

Hi,

We will work on this and will get back to you at the earliest.

Thanks & regards,
Sivaraj K

0 Titusrathinaraj Stalin over 9 years ago

TI__Guru** 116100 points

Can you please make use of NOR flash writer for flashing the bitfile into FPGA via EMIFA interface ?
C:\ti\OMAP-L138_FlashAndBootUtils_2.40\OMAP-L138\CCS\NORWriter

0 J L75 over 9 years ago in reply to Titusrathinaraj Stalin

Prodigy 70 points

Hi, where would I get this utility? I'm having problems finding the correct combination of software to install. I currently have CCS 6.1 installed along quickStartOMAPL1x_rCSL. Am I missing anything else?

Thank you

0 J L75 over 9 years ago in reply to J L75

Prodigy 70 points

Please note that I don't have the EVM, just a C6747 on its own connected to my fpga in a pcb. I can only connect directly to the C6474 but it isn't running a bios or anything like that.

Thanks

0 Titusrathinaraj Stalin over 9 years ago in reply to J L75

TI__Guru** 116100 points

processors.wiki.ti.com/.../Serial_Boot_and_Flash_Loading_Utility_for_OMAP-L137
sourceforge.net/.../

C:\ti\OMAP-L137_FlashAndBootUtils_2_40\OMAP-L137\CCS\NANDWriter

Processors

Processors forum

Uploading bit file to FPGA over EMIFA Example C6747